Here's the Terminal Output from running fswebcam and motion after installation.

Here's the Terminal Output from running fswebcam and motion after installation. I got errors in both. So, I will mess with them later...

Don

You would if you could but you can't so you won't.
don@Fusion-14-BlueFIC ~]$ Fswebcam
bash: Fswebcam: command not found...
Similar command is: 'fswebcam'
don@Fusion-14-BlueFIC ~]$ fswebcam
--- Opening /dev/video0...
Trying source module v4l2...
/dev/video0 opened.
No input was specified, using the first.
Adjusting resolution from 384x288 to 320x240.
--- Capturing frame...
Corrupt JPEG data: premature end of data segment
Captured frame in 0.00 seconds.
--- Processing captured image...
There are unsaved changes to the image.
don@Fusion-14-BlueFIC ~]$ motion
[0] Processing thread 0 - config file /etc/motion/motion.conf
[0] Motion 3.2.12 Started
[0] Motion going to daemon mode
[0] Exit motion, cannot create process id file (pid file) /var/run/motion.pid: Permission denied
don@Fusion-14-BlueFIC ~]$